Kessler REV 2 Pan and Tilt Head Motor 500 series

Kessler REV 2 Pan and Tilt Head Motor 500 series

Nová nízkoprofilová hlava Kessler REV 2 Pan and Tilt Head s motorom 500. *AKCIOVÁ CENA - TOVAR BOL VYSTAVENÝ V NAŠOM SHOWROOME, BEZ ZNÁMOK POUŽÍVANIA*

Technical Specs

REV 2 Head Features & Specifications

- NEW Low Profile Design

- Removable stand-offs for even lower profile (when cable pass-through is not needed)

- Adjustable Tilt arm with 4" of adjustment including 5 different heights

- Choose between 500 or 1000 series motor for different applications

- Billet aluminum with stainless steel hardware construction.

- Dual motors for each axis, provide zero backlash and 100% holding power (no drifting).

- Continuous 360 degree movement on both pan and tilt.

- Superior Dynamic Range. Unit is both faster and slower than other heads at similar price point.

- Ball bearing and belt drive to eliminate gear to gear noise.

- Pass-through axle points, for easy cable routing.

- Cabling is CAT5 / CAT6 cable with RJ45 connectors (standard network cable). NO EXPENSIVE PROPRIETARY CABLES!!-

- Unit Weight: 10 lbs.

- Weight Capacity: 20 lbs.

Dimensions
Arm Extended: 12.5" x 12.5" x 6.25"
Arm Collapsed: 16.5" x 12.5" x 6.25"
(height is reduced by 1.5" with stand-offs removed)

Weight: 9 lbs.


ORACLE Controller Supported Features & Specifications:
- Backlit LCD display with menu and setting values.
- Fully adjustable controls for Max Speed, Dampening, & Dead Band.
- Movement Recording / Memory Function with three memory banks.
- Battery meter for ORACLE battery
- SmartLapse WYSIWYG (What You See Is What You Get) Timelapse mode
- Assignable Premium Multi-Function Joystick controls
- Built-in intervalometer with stand alone, continuous motion, shoot-move-shoot, & stop motion modes (requires Camera Control Module accessory).
- Intervalometer capable of 0.25 sec exposure time for fast shutter (if camera can support the frame rate)
- 2nd axis control while in "Slider" Mode. Control slide and one axis of Revolution Head or Turntable with one ORACLE controller.
- Cabling is CAT5 / CAT6 cable with RJ45 connectors (standard network cable). NO EXPENSIVE PROPRIETARY CABLES!!
- Powered by standard AC power supply with wall plug, or optional 12v DC adapter and battery pack.



As of firmware v2.06.1SL, you can control the elektraDRIVE motor of a slider and one axis of the Revolution Head or the Turntable while in slider mode. To perform 3-axis movements with both the Revolution Head and a elektraDRIVE motor for a slider at the same time, you will need two controllers.

To utilize the intervalometer functionality of the ORACLE, you will need the Camera Control Module.