Kessler REV 2 Pan and Tilt Head Motor 500 + Oracle controller

Kessler REV 2 Pan and Tilt Head Motor 500 + Oracle controller

Nová nízkoprofilová hlava Kessler REV 2 Pan and Tilt Head s motorom 500 + Profesionálne joystickové ovládanie Kesler Oracle controller.

Technical Specs

- NEW Low Profile Design
- Removable stand-offs for even lower profile (when cable pass-through is not needed)
- Adjustable Tilt arm with 4" of adjustment including 5 different heights
- Choose between 500 or 1000 series motor for different applications
- Billet aluminum with stainless steel hardware construction.
- Dual motors for each axis, provide zero backlash and 100% holding power (no drifting).
- Continuous 360 degree movement on both pan and tilt.
- Superior Dynamic Range. Unit is both faster and slower than other heads at similar price point.
- Ball bearing and belt drive to eliminate gear to gear noise.
- Pass-through axle points, for easy cable routing.
- Cabling is CAT5 / CAT6 cable with RJ45 connectors (standard network cable). NO EXPENSIVE PROPRIETARY CABLES!!-
- Unit Weight: 10 lbs.
- Weight Capacity: 20 lbs.

Dimensions
Arm Extended: 12.5" x 12.5" x 6.25"
Arm Collapsed: 16.5" x 12.5" x 6.25"
(height is reduced by 1.5" with stand-offs removed)

Weight: 9 lbs.


ORACLE Controller Supported Features & Specifications:
- Backlit LCD display with menu and setting values.
- Fully adjustable controls for Max Speed, Dampening, & Dead Band.
- Movement Recording / Memory Function with three memory banks.
- Battery meter for ORACLE battery
- SmartLapse WYSIWYG (What You See Is What You Get) Timelapse mode
- Assignable Premium Multi-Function Joystick controls
- Built-in intervalometer with stand alone, continuous motion, shoot-move-shoot, & stop motion modes (requires Camera Control Module accessory).
- Intervalometer capable of 0.25 sec exposure time for fast shutter (if camera can support the frame rate)
- 2nd axis control while in "Slider" Mode. Control slide and one axis of Revolution Head or Turntable with one ORACLE controller.
- Cabling is CAT5 / CAT6 cable with RJ45 connectors (standard network cable). NO EXPENSIVE PROPRIETARY CABLES!!
- Powered by standard AC power supply with wall plug, or optional 12v DC adapter and battery pack.



As of firmware v2.06.1SL, you can control the elektraDRIVE motor of a slider and one axis of the Revolution Head or the Turntable while in slider mode. To perform 3-axis movements with both the Revolution Head and a elektraDRIVE motor for a slider at the same time, you will need two controllers.

To utilize the intervalometer functionality of the ORACLE, you will need the Camera Control Module.

ORACLE Controller Supported Features & Specifications

- Backlite LCD display with menu and setting values
- Fully adjustable controls for Max Speed, Dampening, & Dead Band
- Movement Recording / Memory Function with three memory banks
- Time Lapse control
- Premium Multi-Function Joystick
- Joystick orientation can be easily set in the menu
- Cabling is CAT5 / CAT6 cable with RJ45 connectors (standard network cable). No expensive proprietary cables!
- Powered by standard AC power supply with wall plug, or optional 12v DC adapter and battery pack